A system running but not cooling almost always comes down to charge, airflow, or a failing component — we test all three.
Straightforward flat-rate pricing, quoted after diagnosis.
If you're dealing with warm air blowing from the vents, ice forming on the copper line, or a condenser fan that's stopped spinning outside, you already know a system that's technically running but not actually cooling the house is one of the most misdiagnosed HVAC complaints there is.

Most AC repair problems give some warning before they turn into warm air blowing from the vents, ice forming on the copper line, or a condenser fan that's stopped spinning outside — catching it early usually means a shorter, cheaper fix.
Our technicians treat every AC repair call in Wallace, ID the same way, whether it's a straightforward fix or a stubborn intermittent fault that two other companies already missed.
Every truck across Wallace, ID carries the tools and common parts specific to AC repair, so most calls finish in a single visit.

Every tech carries EPA Section 608 certification, required for legally handling refrigerant.
Trucks stocked and staged across Wallace, ID mean shorter windows than a call-center dispatch model.
Diagnostic first, quote second, work third — that order never changes.
Manifold gauges, digital thermometers, and airflow meters confirm the actual fault, not a guess.
From the first symptom to the final fix, these are the specific AC repair services our Wallace-area crews are equipped for.
Repeated low-charge calls on the same system usually mean an unrepaired leak from a prior visit elsewhere. Techs handling refrigerant charge & leak repair carry the specific parts and tools this job calls for, not a generic kit.
We test motor amperage against rated draw before replacing. Techs handling condenser fan motor repair carry the specific parts and tools this job calls for, not a generic kit.
We check for coil frost, which usually points to airflow or charge issues upstream. Techs handling evaporator coil cleaning & repair carry the specific parts and tools this job calls for, not a generic kit.
A failed compressor is often the last domino, not the first. This is one of the most requested AC repair calls we get across Wallace, ID.
A miscalibrated or miswired thermostat can mimic a full system failure. Techs handling thermostat calibration & wiring carry the specific parts and tools this job calls for, not a generic kit.
Error codes on the wall unit display get cross-referenced against the manufacturer's chart. This is one of the most requested AC repair calls we get across Wallace, ID.

Tell us whether the air is warm, the unit is icing, or it's not running at all — that detail changes what parts ride along.
We text when the tech is en route so you're not watching the driveway.
Superheat, subcounting, and airflow readings get taken before any refrigerant is added.
Most refrigerant and component repairs wrap same-visit.

House was sitting at 84 degrees and the vents were blowing lukewarm air.
Outdoor unit had ice forming on the copper line which I'd never seen before.
They caught it before the compressor overheated and swapped the fan motor same visit.
Their tech knew it on sight and had a replacement part on the truck.

A full diagnostic checks all three before we touch the refrigerant charge.
Ice almost always means something is restricting airflow or refrigerant flow, and running it iced up can damage the compressor.
Adding refrigerant without finding the leak just means another service call later.
Yes, though R-22 supply is limited and increasingly expensive — we'll be upfront if a repair-versus-replace conversation makes more financial sense.
Yes — indoor head units, outdoor condensers, and line sets all fall under our service scope.
Call volume rises with the heat, so arrival windows can extend during heat waves — dispatch gives you a live estimate when you call.

Whether you're in the heart of Wallace or one of the surrounding communities, dispatch routes the closest available technician.
☎ Call +1-866-805-8548 for Wallace Service